FUJITSU M3000 - Manual (Page 157)

Chapter 14 Fan Backplane Replacement 14-5
14.2 Removing the Fan Backplane
1. Remove the signal cable for the operator panel (1 in FIGURE 14-3 ).
The cable is on the right side of the fan backplane.
2. Remove the signal cable connector for the motherboard unit (2 in FIGURE 14-3 ).
The cable connector is on the rear side of the fan backplane.
3. Remove the four screws securing the fan backplane (3 in FIGURE 14-3 ).
FIGURE 14-3 Removing the Fan Backplane
4. Remove the fan backplane from the server, and place it on a conductive mat.
A part
A part
1 2
3
3
3
3