First Virtual Communications 1150E - Manual (Page 33)

Connecting the components
33
separately. To use Power over Ethernet, where power is delivered
over the CAT5 cable, the LAN must support Power over Ethernet, an
AC adapter is not required.
Note 2: You must use CAT5e (or later) cables if you want to use
gigabit Ethernet.
3. Install the headset. Plug the connector into the RJ-9 headset jack
marked with the symbol
) on the back of the phone, and thread the
headset cord through the channels in the stand, so that the headset
cord exits the channel marked with the symbol
).
4. Install the Ethernet cable. Connect one end of the supplied Ethernet
cable to the back of your phone using the RJ-45 connector marked
with the symbol
%, and thread the network cable through the channel
marked with the symbol %.
5. Install the Ethernet cable connecting the PC to the phone (optional). If
you are connecting your PC Ethernet through the phone, connect one
end of the PC Ethernet cable to your phone using the RJ-45
connector marked with the symbol
(, and thread it through the
channel marked with the symbol (. Connect the other end to the
LAN connector on the back of your PC.
6. Install additional cables. If applicable, plug in optional USB devices.
Connect the Ethernet cable to the LAN Ethernet connection. If you
are using an AC power adapter, plug the adapter into an ACM outlet.