Frye FONIX 7000 - Manual (Page 52)

44
FONIX 7000 Hearing Aid Analyzer
If you want to include a label on all printouts by default:
1. Press [MENU] from the Opening screen to enter the Setup menu.
2. Use [∨, ∧] to select Print Label.
3. Use [>] to select ON.
4. Press [MENU] to close the Setup menu.
5. Press [F8] to save the user defaults. This will also save all the other selec-
tions in the Setup menu.
6. Press [EXIT] to return to the Opening screen.
2.4.3 Using the internal printer
The internal printer of the 7000 test system is straight-forward to use. Make
sure the internal printer is selected by following the instructions in the section
above. Press [PRINT] to print any displayed screen. Press the [FEED] button to
feed the thermal paper through the printer without printing.
General Information
The following is useful information:
• Raise “Head-Up” lever to the up position when paper is not loaded, or
when the internal printer is not in use for extended periods of time.
• Frequently inspect the printer for any residue or foreign matter, and clean
as required. Paper residue or foreign matter may shorten the life of the
thermal printer head or platen.
• The 7000 printer mechanism is equipped with a paper back tension
device. This feature is used to eliminate paper migration from side-to-
side. If paper migrates too far to one side, the edge or the paper will
“krinkle” and cause a paper jam. The white plastic spring-loaded back
tension rod located at the back of the printer mechanism provides the
required tension onto the outside of the paper roll. No adjustment is
required for proper operation.
Error Messages:
In the event that an error occurs when printing with the 7000 analyzer, we’ve
included some error codes in the lower right corner of the screen that should
help a FONIX technician troubleshoot the problem. This section describes
those error codes.
There are two categories of errors that can occur with the 7000 printer: initial-
ization errors and printing errors. Initialization errors occur only when the 7000
analyzer is first powered up; this also initializes the printer. Here are the printer
initialization error codes: