FUJITSU T5140 - Manual (Page 31)

Chapter 1 Configuring the System Console 9
■ No parity
■ 1 stop bit
■ No handshaking
2. Establish an ILOM service processor session.
See the ILOM user’s guide for instructions.
3. To connect to the system console, at the ILOM command prompt, type:
The start /SP/console command switches you to the system console.
4. To switch back to the -> prompt, type the #. (Pound-Period) escape sequence.
Characters are not echoed to the screen.
For instructions on how to use the ILOM service processor, refer to the ILOM user’s
guide and the ILOM supplement for your server.
Activating the Network Management Port
The network management port is configured by default to retrieve network settings
using DHCP and allow connections using SSH. You might need to modify these
settings for your network. If you are unable to use DHCP and SSH on your network,
you must connect to the service processor using the serial management port to
reconfigure the network management port. See
“Using the Serial Management Port”
on page 8
Note – The default username when connecting to the service processor for the first
time is root. The default password is changeme. You should assign a new
password during initial system configuration. For more information, refer to your
server installation guide, the ILOM user’s guide, and the ILOM supplement for your
server.
You can assign the network management port a static IP address or you can
configure the port to obtain an IP address using DHCP from another server.
Data centers frequently devote a separate subnet to system management. If your
data center has such a configuration, connect the network management port to this
subnet.
-> start /SP/console
ok #.