FUJITSU T5140 - Manual (Page 34)

12 SPARC Enterprise T5140 and T5240 Servers Administration Guide • February 2008
▼ To Access The System Console Through a Terminal Server
1. Complete the physical connection from the serial management port to your
terminal server.
The serial management port on the SPARC Enterprise T5140 or T5240 server is a
data terminal equipment (DTE) port. The pinouts for the serial management port
correspond with the pinouts for the RJ-45 ports on the serial interface breakout
cable supplied by Cisco for use with the Cisco AS2511-RJ terminal server. If you
use a terminal server made by another manufacturer, check that the serial port
pinouts of the SPARC Enterprise T5140 or T5240 server matches those of the
terminal server you plan to use.
If the pinouts for the server serial ports correspond with the pinouts for the RJ-45
ports on the terminal server, you have two connection options:
■ Connect a serial interface breakout cable directly to the SPARC Enterprise
T5140 or T5240 server. See
“Accessing the Service Processor” on page 8 .
■ Connect a serial interface breakout cable to a patch panel and use the straight-
through patch cable (supplied by your server’s manufacturer) to connect the
patch panel to the server.