FUJITSU T5140 - Manual (Page 59)

Chapter 2 Managing RAS Features and System Firmware 37
▼ To Control the Locator LED
● To turn on the Locator LED, from the ILOM service processor command
prompt, type:
● To turn off the Locator LED, from the ILOM service processor command
prompt, type:
● To display the state of the Locator LED, from the ILOM service processor
command prompt, type:
Note – You do not need Administrator permissions to use the set /SYS/LOCATE
and show /SYS/LOCATE commands
OpenBoot Emergency Procedures
The introduction of Universal Serial Bus (USB) keyboards with the newest systems
has made it necessary to change some of the OpenBoot emergency procedures.
Specifically, the Stop-N, Stop-D, and Stop-F commands that were available on
systems with non-USB keyboards are not supported on systems that use USB
keyboards, such as the SPARC Enterprise T5140 or T5240 servers. If you are familiar
with the earlier (non-USB) keyboard functionality, this section describes the
analogous OpenBoot emergency procedures available in newer systems that use USB
keyboards.
OpenBoot Emergency Procedures for SPARC
Enterprise T5140 and T5240 Systems
The following sections describe how to perform the functions of the Stop commands
on systems that use USB keyboards. These same functions are available through
Integrated Lights Out Manager (ILOM) system controller software.
-> set /SYS/LOCATE value=Fast_Blink
-> set /SYS/LOCATE value=off
-> show /SYS/LOCATE