Figure 1-4, Table 1-2 – FUJITSU T5140 User Manual
Page 35
Chapter 1
Configuring the System Console
13
FIGURE 1-4
Patch Panel Connection Between a Terminal Server and a SPARC Enterprise
T5140 or T5240 Server
If the pinouts for the serial management port do not correspond with the pinouts
for the RJ-45 ports on the terminal server, you must make a crossover cable that
connects each pin on the SPARC Enterprise T5140 or T5240 server serial
management port to the corresponding pin in the terminal server’s serial port.
shows the crossovers that the cable must perform.
TABLE 1-2
Pin Crossovers for Connecting to a Typical Terminal Server
SPARC Enterprise T5140 or T5240 Serial Port
(RJ-45 Connector) Pin
Terminal Server Serial Port Pin
Pin 1 (RTS)
Pin 1 (CTS)
Pin 2 (DTR)
Pin 2 (DSR)
Pin 3 (TXD)
Pin 3 (RXD)
Pin 4 (Signal Ground)
Pin 4 (Signal Ground)
Pin 5 (Signal Ground)
Pin 5 (Signal Ground)
Pin 6 (RXD)
Pin 6 (TXD)
Pin 7 (DSR /DCD)
Pin 7 (DTR)
Pin 8 (CTS)
Pin 8 (RTS)