Stop-n functionality, To restore openboot configuration defaults – FUJITSU T5140 User Manual
Page 60
38
SPARC Enterprise T5140 and T5240 Servers Administration Guide • February 2008
Stop-N Functionality
Stop-N functionality is not available. However, you can closely emulate the Stop-N
functionality by completing the following steps, provided the system console is
configured to be accessible using either the serial management port or the network
management port.
▼
To Restore OpenBoot Configuration Defaults
1. Log in to the ILOM service processor.
2. Type the following command:
Note –
If you do not issue the stop /SYS and start /SYS commands or the
reset /SYS
command within 10 minutes, the host server resets the bootmode state
to normal.
You can issue the show /HOST/bootmode command without arguments to
display the current setting
3. To reset the system, type the following commands:
-> set /HOST/bootmode state=reset_nvram
-> ->
-> show /HOST/bootmode
/HOST/bootmode
Targets:
Properties:
config = (none)
expires = Fri Oct 19 17:53:20 2007
script = (none)
state = reset_nvram
-> reset /SYS
Are you sure you want to reset /SYS (y/n)?
y
->