FUJITSU T5140 - Manual (Page 95)

73
A P P E N D I X
A
OpenBoot Configuration Variables
TABLE A-1 describes the OpenBoot firmware configuration variables stored in non-
volatile memory on the system. The OpenBoot configuration variables are printed
here in the order in which they appear when you issue the following command:
ok printenv
TABLE A-1 OpenBoot Configuration Variables Stored on the System Configuration Card
Variable Possible Values Default Value Description
local-mac-address? true, false true If true, network drivers use their own
MAC address, not the server MAC address.
fcode-debug? true, false false If true, include name fields for plug-in
device FCodes.
scsi-initiator-id 0-15 7 SCSI ID of the Serial Attached SCSI
controller.
oem-logo? true, false false If true, use custom OEM logo. Otherwise,
use the server manufacturer’s logo.
oem-banner? true, false false If true, use custom OEM banner.
ansi-terminal? true, false true If true, enable ANSI terminal emulation.
screen-#columns 0-n 80 Sets number of columns on screen.
screen-#rows 0-n 34 Sets number of rows on screen.
ttya-rts-dtr-off true, false false If true, operating system does not assert
rts
(request-to-send) and dtr
(data-transfer-ready) on serial management
port.
ttya-ignore-cd true, false true If true, operating system ignores carrier-
detect on TTYA port.
ttya-mode 9600,8,n,1,- 9600,8,n,1,- TTYA port (baud rate, bits, parity, stop,
handshake). The serial management port
only works at the default values.