FUJITSU T5140 User Manual
Page 33
Chapter 1
Configuring the System Console
11
■
If you have configured your server to use static IP addresses, but want to reset
your network to use Dynamic Host Configuration Protocol (DHCP), type the
following commands:
4. Issue the following command to verify network settings:
To connect through the network management port, use ssh to the IP address
shown by
Accessing the System Console Through a
Terminal Server
The following procedure assumes that you are accessing the system console by
connecting a terminal server to the serial management port (SER MGT) of your
server.
-> set /SP/network pendingipdiscovery=dhcp
Set ’pendingipdiscovery’ to ’dhcp’
-> set /SP/network commitpending=true
Set ’commitpending’ to ’true’
->
-> show /SP/network
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = none
ipaddress = 129.148.57.125
ipdiscovery = static
ipgateway = 129.148.57.254
ipnetmask = 255.255.255.0
macaddress = 00:14:4F:86:62:ED
pendingipaddress = 129.148.57.125
pendingipdiscovery = static
pendingipgateway = 129.148.57.254
pendingipnetmask = 255.255.255.0
state = enabled