FireplaceXtrordinair 44 DV XXL EF - Manual (Page 39)

Operation
3 9
Travis Industries 4050114 1 0 0 - 0 1 1 4 9
Starting the Fireplace for the First Time
+ Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will cure the
painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This is normal. We
recommend opening a window to vent the room.
+ Dust may accumulate inside the convection area of the heater when left idle. Once the heater is re-started, a
“smoky” smell may be created (similar to a baseboard heater when it is re-started).
+ Condensation may appear on the glass each time you start the fireplace - this is normal.
+ Blue Flames will occur on the fireplace when it first comes on. After fifteen minutes the flames will turn a
more realistic yellow and orange color.
? Certain installations use a remote "wall switch" to turn the fireplace on and off. If this is the case, leave the
ON/OFF switch "ON".
Turning the Fireplace On and Off
OFF ROOM TEMP
°F
°F
SET TEMPTIMER MIN
Time Set
Time Cancel
A u
t o
OF
F
ON
Use this switch to
turn the main burner
on and off manually.
After the pilot has been started...
See the instructions included
with the remote for details on
operation.
For systems with wall
thermostats, use this switch to
control the temperature (right
is hotter, left cooler). Some
systems require the on/off
switch to be on.
See the instructions
included with the
remote for changing
the battery.
! Do not place any combustible items on top of or directly in front of the fireplace, even temporarily. The
optional thermostat may start the fireplace causing a combustible item to ignite.
? If the fireplace turns on and off frequently while using the thermostat, you may want to adjust the flame height
down until it produces just enough heat needed.
Adjusting the Flame Height
+ Your fireplace has an adjustable flame to tailor the look and heat output to your specific needs. It is adjusted by
turning the middle dial on the gas control valve.
Flame Height
Adjustment Knob
Index Mark
Turn counter-clockwise to adjust the flame higher, clockwise to lower.