FireplaceXtrordinair 44 DV XXL EF - Manual (Page 8)

8
Installation
(for qualified installers only)
Travis Industries 4050114 1 0 0 - 0 1 1 4 9
8
Installation Overview
Non-combustible facing
(see the section "Facing
Requirements")
See the section "Acceptable
Vent Lengths"
See the section "Horizontal Termination
Requirements"
See the section
"Gas Line Installation"
See the section
"Electrical Connection" See the section
"Mantel Requirements"
Insulation must not fill the 1"
clearance around the back and sides
of the fireplace.
See the section "Fireplace
Placement Requirements"
3-1/2" Min.
See the section
"Vent Requirements"
See the section "Minimum
Framing Dimensions"
See the section
"Hearth Requirements"
Drywall
Nail
Down
Plate
See "Power Heat
Vent" in the optional
equipment section.
This grommet and hole is for
thermostat wire (on both sides)
Recommended Installation Procedure
1 Frame the opening for the fireplace. Make sure to allow for vent installation and the type of installation (corner
or flat wall).
2 Insert the fireplace into the framing. Slide it back until the firebox front face is flush with the framing members.
Verify all clearances at this point.
3 Secure the fireplace to the floor by screwing or nailing through the nail-down plates (found on both sides and
back of the fireplace).
4 Complete the gas line installation.
5 Complete the electrical hook-up.
6 Complete the vent installation.
7 Install the hearth (if applicable).
8 Install the facing.
9 Install the mantel (if applicable).