FieldServer FS-8700-84 User Manual
Page 2
FS-8700-84_Lutron_eLumen
Manual
Table
of
Contents
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: [email protected]
TABLE OF CONTENTS
1.
Lutron eLumen Description .......................................................................................... 1
2.
Driver Scope of Supply................................................................................................... 2
1.01
Supplied by FieldServer Technologies for this driver ............................................ 2
1.02
Provided by the Supplier of 3
rd
Party Equipment ................................................... 2
2.1.1.
Required 3
rd
Party Hardware .............................................................................. 2
3.
Hardware Connections ................................................................................................... 3
4.
Configuring the FieldServer as a Lutron eLumen Client ...................................... 5
1.03
Data Arrays/Descriptors ............................................................................................. 5
1.04
Client Side Connection Descriptions ........................................................................ 6
1.05
Client Side Node Descriptors .................................................................................... 6
1.06
Client Side Map Descriptors ...................................................................................... 7
4.1.1.
FieldServer Related Map Descriptor Parameters............................................ 8
4.1.2.
Driver Related Map Descriptor Parameters...................................................... 8
4.1.3.
Timing Parameters ............................................................................................. 10
4.1.4.
System Monitor Command – Time Now ......................................................... 11
4.1.5.
System Monitor Command – Astro Times ...................................................... 11
4.1.6.
System Monitor Command – Date ................................................................... 12
4.1.7.
System Monitor Command – Code Revision Level....................................... 12
4.1.8.
System Monitor Command – Bootcode Revision Level ............................... 12
4.1.9.
System Monitor Command – Serial Number.................................................. 13
4.1.10. System Monitor Command – Area Status ...................................................... 13
4.1.11. System Monitor Command – Timeclock Status ............................................. 14
4.1.12. System Monitor Command – Zone Intensity .................................................. 14
4.1.13. System Monitor Command – Request Panel Emergency Status ............... 15
4.1.14. System Monitor Command – System Variable Value ................................... 15
4.1.15. System Monitor Command – Wallstation Status ........................................... 16
4.1.16. System Monitor Command – Switch Status ................................................... 16
4.1.17. System Control Commands containing no Parameters: – Halt Zone......... 17
4.1.18. System Control Commands containing no Parameters: – Stop Scene
Ramp Up ............................................................................................................................... 17
4.1.19. System Control Commands containing no Parameters: – Select System
Scene(s) 18
4.1.20. System Control Commands containing no Parameters: – Disable
Timeclock until Enabled...................................................................................................... 18
4.1.21. System Control Commands containing no Parameters: – Disable timeclock
until end of day or enable issued ...................................................................................... 18
4.1.22. System Control Commands containing no Parameters: – Re-enable
timeclock with complete catchup ...................................................................................... 19
4.1.23. System Control Commands containing no Parameters: – Re-enable
timeclock and do previous event....................................................................................... 19
4.1.24. System Control Commands containing no Parameters: Standard re-enable
timeclock ............................................................................................................................... 19
4.1.25. System Control Commands containing no Parameters: Run script(s)....... 20