FIC A360 - Manual (Page 128)

Maintenance & Disassembly
4. Underneath the palm-rest cover, you will see the glidepad module assembly. Remove the
five screws on the glidepad converter board where the glidepad wire cable is connected.
Figure 5-5 Removing Palm Rest / Glide Pad
5. When the converted board is removed, you can remove the select-button bracket casing
covering the glidepad board.
6. Replace a new glidepad module and reverse the procedure to reassemble.
5.5.4 Removing the Internal Hard Disk Drive
The notebook provides a built-in hard disk for the primary IDE controller. The HDD is an
industry standard 2.5” IDE disk drive with a maximum height of 9.5mm.
1. Find out the built-in hard disk secured with one screw at the upper right corner of the hard
disk. Remove this screw and carefully pull the hard disk module from the connector.
Glidepad
module
Palm-rest
panel/cover
Connectors
screws
Figure 5-6 The disassembly of Hard Disk Drive
5-8
FIC A360 Service Manual