FIC A360 - Manual (Page 131)

Maintenance & Disassembly
5.5.7 Removing the CPU
1. For doing this disassembly, you need first to do the disassembly for the keyboard cover,
keyboard, and heat sink plate.
2. Use a flat screw driver and insert it into the CPU socket and tilt it towards in front of you
to unlock CPU from the socket. It’s recommended to use the protective tooling securing
CPU against damage.
Insert flat screw driver into
the CPU socket. To unlock
CPU, Tilt it in front of you.
CPU Protective
Tooling
Figure 5-12 Remove CPU
5.5.8 Removing the CD-ROM Module
The procedure for removing and replacing the CD-ROM module is as follows:
1. Before removing the CD-ROM module, you need to disassemble keyboard first.
2. To remove the CD-ROM module, remove one screw securing the CD-ROM bracket and
push out the drive from the connector.
FIC A360 Service Manual 5-11