Internal hdd sub-menu, Outline of the a360 – FIC A360 User Manual
Page 33
Outline of the A360
1-22
FIC A360 Service Manual
Internal HDD Sub-Menu
P h o e n i x B I O S S e t u p U t i l i t y
Main
Internal HDD [10056MB]
Item Specific Help
Type:
[
Auto
]
User = you enter
Cylinders:
[16383]
Parameters of hard-disk
Heads:
[16]
Drive installed at this
Sectors:
[63]
Connection.
Maximum Capacity:
10056MB
Auto = autotypes
Hard-disk drive
Multi-Sector Transfers:
[16 Sectors]
Installed here
LBA Mode Control:
[Enabled]
1-39 = you select
32 Bit I/O:
[Disabled]
pre-determined type of
Transfer Mode:
[FPIO 4 / DMA 2]
hard-disk drive
SMART Monitoring:
Enabled
Install here.
Ultra DMA Mode:
[Mode 4]
CD-ROM = a CD-ROM drive
is installed here.
ATAPI Removable =
Removable disk drive is
installed here
F1
Help
K
Select Item
−/+
Change Values
F9
Setup Defaults
Esc
Exit
ÅÆ
Select Menu
Enter
Select
Sub-Menu
F10
Save and Exit
Figure 1-14
Internal HDD/CD-ROM Sub-Menu
Type:
[None] / [CD-ROM] / [User]
/ [Auto]
Select the drive type corresponding to the fixed
disk installed in your system. If type USER is
selected, Cylinders, Heads & Sectors edited
directly.
Cylinders:
[16383]
(BIOS auto detect, for information only)
Heads:
[16]
(BIOS auto detect, for information only)
Sectors:
[63]
(BIOS auto detect, for information only)
Maximum Capacity:
10056MB
(BIOS auto detect, for information only)
Multi-Sector
Transfers:
[Disabled] / [2 Sectors] /
[4 Sectors] / [8 Sectors] /
[16 Sectors]
Determine the number of sectors per block for
multiple sector transfers.
LBA Mode Control:
[Disabled] / [Enabled]
Enabling LBA causes Logical Block Addressing
to be used in place of Cylinders, Heads &
Sectors
32 Bit I/O:
[Disabled] / [Enabled]
This setting enables or disables 32 bit IDE data
transfers
Transfer Mode:
[Standard] / [Fast PIO 1] /
[Fast PIO 2] / [Fast PIO 3] /
[Fast PIO 4] / [FPIO 3 /
DMA1] / [FPIO 4 / DMA2]
Select the method for moving data to/from the
drive. Autotype the drive to select the optimum
transfer mode
SMART Monitoring
[Disabled] / [Enabled]
HDD provides the function of SMART Monitoring
Ultra DMA Mode:
[Mode 1] / [Mode 2]
(BIOS auto detect, for information only)