FIC A360 - Manual (Page 26)

Outline of the A360
FIC A360Service Manual 1-15
diskette for copying and transferring data files. In the BIOS Setup program of the notebook,
you also could disable the FDD option or set a password option when accessing the drive.
1.4.5 The Rear Side of the Notebook
n AC Power Port o Printer Port p TV-Out Port
q Air-Outlet Vent r CRT Port s Series Port
t LAN Port u Modem Port v IEEE1394 Port
w USB Port
Figure 1-11 Rear Side of the Notebook
AC Power Port
Lets you attach the notebook to the AC power source using the AC adapter that comes with
your system. Keep the system connected to AC power whenever possible to keep the battery
pack and internal CMOS battery charged. The Battery Charge LED will activate whenever
the battery is being recharged.
Printer Port (LPT1)
The printer port lets you connect a 25-pin parallel device such as printer, ZIP drive, or remote
data transfer cable. Many operating systems and software applications refer to this port as
LPT1. You can run the BIOS setup program to change the configuration of the parallel port to
Uni-directional, ECP or EPP mode.
L
The default setting for the parallel port on your notebook computer is set to EPP
mode. Some parallel devices may not function with the default setting. You need
to run the BIOS Setup program to adjust the settings.
TV-Out Port
Lets you connect to a RCA TV connector for presentation or VCD, DVD watching.
Air-Outlet Vent
Emits the heat out of your computer and keeps it within operating temperature.
VGA Port (CRT)
The VGA port lets you connect an external VGA (CRT) monitor to the notebook. You can
also run the LCD and the external CRT monitor display simultaneously; or switch it to CRT
only using the function hot-key (Fn+F3). When switch to CRT only, you can set the display
resolution up to 1280x1024 at 16M colors (32-bit true color).