Safety notes, Installation – Motorola ATCA-717 User Manual
Page 20
20
PENT/ATCA−717
Safety Notes
This section provides safety precautions to follow when installing, operating, and
maintaining the product.
We intend to provide all necessary information to install and handle the product in this
manual. However, as the product is complex and its usage manifold, we do not guarantee
that the given information is complete. If you need additional information, ask your
Motorola representative.
The product has been designed to meet the standard industrial safety requirements. It
must not be used except in its specific area of office telecommunication industry and
industrial control.
Only personnel trained by Motorola or persons qualified in electronics or electrical
engineering are authorized to install, remove or maintain the product. The information
given in this manual is meant to complete the knowledge of a specialist and must not
be taken as replacement for qualified personnel.
EMC
The blade has been tested in a standard Motorola system and found to comply with the
limits for a Class A digital device in this system, pursuant to part 15 of the FCC Rules,
EN 55022 Class A respectively. These limits are designed to provide reasonable
protection against harmful interference when the system is operated in a commercial
environment.
The blade generates and uses radio frequency energy and, if not installed properly and
used in accordance with this guide, may cause harmful interference to radio
communications. Operating the system in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his
own expense.
Installation
Damage of Circuits
Electrostatic discharge and incorrect blade installation and removal can damage circuits
or shorten their life.
Before touching the blade or electronic components, make sure that you are working in
an ESD−safe environment.
Data loss
Removing the blade with the blue LED still blinking causes data loss.
Wait until the blue LED is permanently illuminated, before removing the blade.