Motorola ATCA-717 - Manual (Page 93)

BIOS Messages BIOS
PENT/ATCA−717 93
BIOS Messages
If your system fails after you made changes in the setup menus, you may be able to
correct the problem by entering setup and restoring the original values.
a
Message Explanation a Corrective Action
nnnn Cache SRAM Passed nnnn is amount of system
cache in KBytes
successfully tested None
CD−ROM Drive Identified Autotyping identified
CD−ROM Drive None
Diskette drive A
errorDiskette drive B error Drive A: or B: fails the BIOS
POST disk tests. Drive is
selected via setup but
either not present or defect. Check that drive is defined
with proper disk type in
setup, that disk drive is
attached correctly and that
controller is enabled.
Entering SETUP ... Starting setup program None
Extended RAM Failed at
offset: nnnn Extended memory not
working or not configured
properly at offset nnnn Check if memory modules
are installed correctly.
Otherwise contact your
local sales representative or
FAE for further support.
nnnn Extended RAM Passed nnnn is amount of RAM in
MBytes successfully tested. None
Failing Bits: nnnn nnnn is a map of the bits at
the RAM address (in
system, extended or
shadow memory) which
failed the memory test.
Each 1 (one) in the map
indicates a failed bit. Check if memory modules
are installed correctly.
Otherwise contact your
local sales representative or
FAE for further support.
Fixed Disk 0 Failure
Fixed Disk 1 Failure
Fixed Disk Controller
Failure Fixed disk not working or
not configured properly Check if fixed disk is
attached properly. Run
setup to be sure the
fixed−disk type is correctly
identified.
Fixed Disk 0...3 Identified Autotyping identified
specified fixed disk None
Incorrect Drive A type −
run SETUP
Incorrect Drive B type −
run SETUP Type of floppy drive not
correctly identified in setup Check for correct floppy
drive in setup.
Keyblade controller error Keyblade controller failed
test Replace keyblade