Motorola ATCA-717 - Manual (Page 52)

Installation On−Board Hardware Accessories
52 PENT/ATCA−717
3. Plug CompactFlash into socket
4. Close locking bow over CompactFlash disk
Note: a The locking bow must enclose the disk completely. a
Removal Procedure
1. Open locking bow
2. Take CompactFlash disk ′s ends and pull CompactFlash disk carefully out of
socket
3. Close locking bow again
CMC Debug Module
A CMC debug module is available as accessory kit for the blade. It is called
ACC/ATCA−CMC−MODULE and provides two serial and one keyboard/mouse
interface at its face plate. The CMC debug module is installed into PMC slot 4. For further
details refer to the
a ACC/ATCA−CMC−MODULE Installation Guide. aa