Marantz RC1200 - Manual (Page 23)

ENGLISH
• If, while programming, no buttons are
pressed for approximately 1 minute,
the remote controller will automatically
return to normal mode, and no macro
will be programmed in the memory.
4. When you are finished programming
macros, use a ballpoint pen or other
sharp point to press the
MACRO button
x. LCD A will display
END , and the
display will return to normal.
• Macros cannot be programmed for the
MODE
z,
MACRO
x,
< •
3 ⁄1,
VOL
/ ., MEMO
⁄6 or
CLEAR
⁄5 buttons.
Although function operations in the
Macro Mode can be programmed
more than once, only the first function
memorized in the ten function buttons
including LD, CD, TV--but not the AMP
button--will be sent from the remote
controller (the amplifier or receiver
function will change). For this reason,
it is not possible to select multiple
amplifier functions in a macro button.
(If the AMP button is programmed, the
same operations as those in the other
function buttons will be performed.)
Therefore, when executing operations
in the Macro Mode, what happens is
that, starting with the second function
operation, only the function mode of
the remote controller is changed, and
no signals are sent.
EDITING MACROS
Macros may be edited using following
procedure.
1. Use a ballpoint pen or other sharp point to
press the
MACRO button x until the
MACRO and LEARN indicators are
displayed blinking on the LCD.
2. Press the Function button , to be
changed. Let’s use the example of the
laser disc player, by pressing the
LD
Function button ,.
• LD-M is displayed blinking on LCD
A.
• The number of steps in the completed
macro is highlighted on LCD
C. In this
example there are 3 macro programs
in memory.