Marantz RC1200 - Manual (Page 30)

ENGLISH
ON
OFF
ON
/ O
FF
S
OURCE
MA
CRO
MO
DE
LEARNING REMOTE CONTROL
RC
1
200 PO
WER
ON
OFF
ON
/
O
FF
S
OURCE
MA
CRO
MO
DE
LEARNING REMOTE CONTROL
RC
1
200
PO
WER
5cm
ON OFF ON / OFF
SOURCE
MACRO MODE
LEARNING REMOTE
CONTROL RC 1200
POWER
USING THE CLONE MODE
All the codes which have been programmed
can be copied altogether into another RC1200
remote controller by a few simple operations.
(Macros and the set-up contents will also be
copied.)
Note:
The clone function cannot be used for
copying unless the same model (RC1200)
is used for the remote controllers at the
sending and receiving ends.
1. Place the light sensor (in the head section)
of the remote controller at the receiving
end about 5 centimeters (2 inches) away
from and directly in front of the transmitter
(also in the head section) of the remote
controller at the sending end.
2. Use a ballpoint pen or other sharp point to
press the
MODE button z on the sending
unit to call up the CLONE and TX
displays. CLONE appears at LCD
A and
TX at LCD
B.