Marantz RC1200 - Manual (Page 25)

ENGLISH
MEMO CLEAR GUIDE MUTE
C D DVD CD-R/MD
DSS T V VCR
AMP L D TUNER TAPE
AUX
AUTO DOLBY THX DTS HALL
CLEAR
C D DVD CD-R/MD
DSS T V VCR
AMP L D TUNER TAPE
AUX
• If while editing macros no buttons are
pressed for approximately 1 minute,
the remote controller will automatically
return to normal mode, and no macro
changes will be programmed in the
memory.
4. When you are finished editing macros,
use a ballpoint pen or other sharp point to
press the
MACRO button x. END will be
displayed on LCD
A and the display will
return to normal.
Note:
When the Jog Dial m has been programmed
i n a m a c r o , c h a n g i n g t h e f u n c t i o n
i m m e d i a t e l y b e f o r e c a u s e s t h e j o g
c o m m a n d s i m m e d i a t e l y a f t e r t o b e
automatically changed to the commands of
the new function. (The commands are
changed to the commands on the same
page number of the new function.)
USING MACROS
The following procedure will show how to use
the function buttons for which you have
programmed macros.
1. Press the Function button , for the
desired macro for 3 seconds. MACRO is
displayed on LCD
A for approximately 1
second, after which the number of steps
in the macro is displayed on LCD
C.
• The remote controller will do nothing if
no macros are programmed. The
macro steps are executed in order
and the names of their buttons are
displayed on the LCD. Also, the step
n u m b e r s d i s p l a y e d o n L C D
c
disappear as each step is executed.
2. After all macro commands have been
transmitted, the remote controller returns
to normal mode.
• To cancel the transmission of a
programmed macro, use the v Cursor
button ⁄0 (STOP button).