Monarch Instrument 9830TM - Manual (Page 11)

9820/9830/9835 Service Manual Printer Overview and Installation
2 TC9830SM Rev. B 7/98 Confidential July 1998
Fuse, Inlet Module: 4.0 amp, 250 V Slo-Blow®
(1 required)
Fuse, Main PCB 7.0 amp, 125 V Slo-Blow
(Soldered radial leads)
Tear Bar: 9830/9835 (Service Installed)
Programming: Flash
Communications: Parallel Port; IEEE 1284
compliant or
Centronics Mode
Operating With Ribbon
Limits: 40 to 95 degrees F
(4 to 35 degrees C)
Without Ribbon
40 to 104 degrees F
(4 to 40 degrees C)
Storage 15 to 120 degrees F
Limits: (-10 to 49 degrees C)
Relative 5 to 90 % Non Condensing
Humidity:
Display: Liquid Crystal Display
3 numeric digits
Light Emitting Diodes
POWER green
SUPPLIES amber
PAUSED amber
Thermal Thin Film
Printhead: 4.15 inches (105mm) wide
832 dots
203 dots/inch (8 dots/mm)
0.0049 inch dot width,
( 0.1245 mm), center-center
Printing Thermal Transfer
Methods: Thermal Direct
Supply Types: 9820 – labels only
9830 -- labels only
9835 -- labels or tags
Ribbon Types: Roll (Non Cartridge)
Standard
Smudgeless
Durable
Steam Resistant
High Energy (9830/9835)
Ribbon Length 23,600 inches (600 m)
Ribbon Widths: 1.3 inches (33 mm)
1.6 inches (41 mm)
2.16 inches (55 mm)
3.15 inches (80 mm)
4.13 inches (105 mm)
Max Ribbon 3.6 inches (91 mm)
Roll O.D.
Ribbon Storage: 41 to 95 degrees F
(5 to 35 degrees C)
Print Speed: 2D Bar Code
2.5, 4, or 6 inches/sec
Serial Bar Code
2.5 inches/sec
Max Print Image: 4 inches wide (102 mm)
16 inches long (405 mm)
Max Print +/- 0.050 inches (1.3 mm)
Tolerance: (side to side)
Feed Method: On-Demand, Continuous, and
optional Peel Mode
STOCK SPECIFICATIONS
Ribbon: Thermal Transfer
Requirements
Stock Width: 1.2 inches (31mm)
4.25 inches (108mm) max
Version 5.2 or .75 inches (19mm) min
greater width:
Stock Length: 1 inch (25mm) min
16 inches (405mm) max
12 inches (305mm) max 9820
Version 5.2 or .75 inches (19mm) min
greater length:
Cut Length: 1.2 inches (31mm) min with
optional knife installed
Stock 0.007 inches min
Thickness: (0.18mm)
0.010 inches max
(0.25mm)
Stock Roll: Outside Diameter
9.375 inches ( 229 mm)
Inside/Core Diameter
3-4 inches (102 mm)
8100 inches (200 m) long
Stock Output: Roll or Fanfold
Stock Type: Die cut without Black Mark
Black Mark
Continuous
Coated Supplies
Version 5.2 or Die Cut Edge
greater stock type: Black Mark
Continuous
Center or Edge Aperture