Monarch Instrument 9830TM - Manual (Page 13)

9820/9830/9835 Service Manual Printer Overview and Installation
4 TC9830SM Rev. B 7/98 Confidential July 1998
1. Locate Upper or Lower DIP Switch block as
shown in Figure 1-3.
2. Turn printer off and change individual DIP
switches as required. Use Table 1-1 as a guide.
3. Daughter board SW1 settings are factory set.
However, when replacing the Control Board
Assembly, the new board must be set as shown
in Table 1-1.
Table 1 - 1. Daughter Board DIP Switches
SW1
Model #
SW2
Peel
SW3
Not used
SW4
Fox IV
SW5
Paxar CL
SW6
Memory
9820 OFF OFF OFF OFF OFF OFF
9820 with new
sensing system
ON OFF OFF OFF OFF OFF
9830 No Peel OFF OFF OFF OFF OFF ON
9830 With Peel OFF ON OFF OFF OFF ON
Fox IV
printer/applicator
OFF ON OFF ON OFF ON
Paxar CL OFF ON OFF OFF ON ON
9835 With Peel ON ON OFF OFF OFF ON
9835 With Knife ON OFF OFF OFF OFF ON
9835 No Peel/Knife ON OFF OFF OFF OFF ON
FUSE REPLACEMENT
Refer to the Operator’s Handbook for fuse replacement procedures.
CONNECTING TO A HOST
For instructions on connecting the printer to a host, refer to the Operator’s Handbook.
Figure 1 - 3. SW2/SW3 DIP Switch Location
Upper DIP Switches
Lower DIP Switches