Metrologic Instruments Metrologic Scanner MLPN 2407 - Manual (Page 60)

MetroSelect ™
Enable “F/L” Laser Command *Disable “F/L” Laser Command
Do not monitor “F/L” commands. When enabled, the scanner will turn
o ff the laser after the scanner
receives an ASCII “F” character. The
laser will turn on after it receives an
ASCII “L” character.
Motor On/Off Using
M/O Commands
*Disable M/O
Commands
When enabled, the motor will turn on
after the scanner receives an ASCII
“M” character. The scanner will turn
o ff the laser and motor after it
receives an ASCII “O” character.
For use with omnidirectional
scanners only.
Do not monitor M/ O commands.
D-19
118014 118004
118213 118203