Monessen Hearth DIRECT VENT MLDV500 - Manual (Page 44)

44 75D0004
MLDV Series Gas Fireplace
FEATURES
Command Center
• Easy Access Function Operation and System Configuration
• Operation Confirmation/Fault Diagnostic Indications (LED/
Buzzer)
• ON/OFF/HI/Med/Low Operation
• Optional Wall Mounting
Control Board
• Electronic Ignition
• Pilot Lockout safety feature
• Electric Power Regeneration from Thermopile to save battery
• 6-hour Automatic Shut Down Option
• Convenient NG/LP Gas Type Conversion
• Standing Pilot/Intermittent pilot Conversion
• Previous settings Restoration Ability (Memory Off)
• Uninterrupted Operation During Power Outage (Automatic
Battery Backup)
• ON/OFF RF Remote Receiver
• Optional Transmitter Learn Capability
AC Module Board (Optional, requires TSFSC Remote)
• Easy Snap-on Design
• Embedded Compact 10 VAC Adapter with Auto Battery Back
up Feature
• Remote Controlled 3-step Blower, Lighting, and On/Off Auxil-
iary AC Outputs
Transmitter (Optional)
TSFSC TSTSC TSMSC RTSC RMSC
Three Flame Height Settings X X X X X
Low battery Indication for Transmitter X X X X X
Child Proof Lock-out X X X X X
LCD Backlight X X X X X
Security Codes 16 X X X X X
Countdown 6 hr Timer X X X -- --
Standard Thermostatic Control Mode X X -- X --
Smart Mode Thermostat (Auto Flame & Blower Modulation) X X -- -- --
Three Brightness Settings for Lights X -- -- -- --
Three Speed Control for Blower X -- -- -- --
On/Off Auxiliary X -- -- -- --
Programmable Timer to turn blower on and off X -- -- -- --
BATTERY INSTALLATION
The Command Center uses four (4) "AA" batteries as back up for power outages. The system can operate for ap-
proximately six (6) months on battery power.
To Install Batteries (not included):
1. Press down the battery door tabs and pull out to remove battery door.
. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system will operate without power.
5. The batteries should be replaced when the LED indicates low battery or at least once a year.
SIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONS
FP1917
Signature components
8/08
RF Receiver
ON/OFF
NG/LP
Conversion
To Thermopile
To Sensor
To Sparker
To Command Center
To Stepper Motor
To Valve
Battery Door
Master Switch
ON
LED
OFF
Control Board
Command
Center
Figure 62 -
Signature Command System Components
6 V A/C
Adapter