IBM INFOPRINT 6500 - Manual (Page 112)

Chapter 4 Windows Ethernet Interface Configuration
112
Windows Ethernet Interface Configuration
The IP address and subnet mask are mandatory TCP/IP settings
and are needed before the print server can be detected on the
network. There are also additional optional settings. This section
offers alternative methods for configuring your Ethernet Interface in
a Windows environment and describes some of the more common
optional settings available.
Mandatory
Since TCP/IP is used for Windows printing, the Ethernet Interface
must be configured with a minimum of an IP address and subnet
mask before it can be seen on the network.
Optional
Additional settings, like routing entries, can be configured. This
allows communication across subnets when no other router exists.
You can configure the Ethernet Interface from the printer control
panel, Web browser, host commands, or other IBM utility software.
To configure these options, see “Configuration Tools” on page 52.
Configuration Using ARP
To configure the Ethernet Interface with its IP settings using a
manual arp command:
1. Log on to a Windows station with TCP/IP loaded and located
on the same subnet as the Ethernet Interface.
2. Find the Ethernet address for the Ethernet Interface on the
configuration printout. It must be entered as part of this
procedure.