IBM INFOPRINT 6500 - Manual (Page 343)

Store Commands
343
store tn dest <dxprn> [-]autoconnect
Example: store tn dest d1prn autoconnect
Store the state of the autoconnect flag. If the autoconnect flag
is enabled the Ethernet Interface TN client will attempt a
connection and binding with the specified TN host
automatically on power-up. This connection sequence will be
repeated every 60 seconds until successful or the autoconnect
flag is disabled.
See “tn dest destination start | stop” command.
Default: disabled
store tn dest <dxprn> copytimeout
Example: store tn dest d1prn copytimeout 1000
Store the value of the copytimeout. When consecutive
TN5250/3270 jobs are sent to the Ethernet, they are treated
differently depending how soon they arrive. In an attempt to
provide a perception of collation when multiple copies are sent
from one host, if the time between jobs is less than the
copytimeout value then they are treated as copies and the job
is given precedence over other host documents. This keeps
documents, which are sent in rapid succession together as if
they were copies of the same document. A higher value
improves the likelihood of collation but impacts performance.
Default: 500
store tn from default|current
Example: store tn from default
Store all tn default settings to flash memory so that they are
retained after power up.