IBM INFOPRINT 6500 - Manual (Page 360)

Chapter 16 Complete Command List
360
list sysinfo
List the current Ethernet Interface system information (e.g.,
contact name and protocol stacks enabled).
list tcpip
List all current TCP/IP network settings (e.g., IP address and
subnet mask).
list test
List the status of output tests on the I/O ports.
list tn
List all current tn protocol settings.
list uptime
Lists how long the Ethernet Interface Card has been up and
running from the last reset.
list user
List the current user definitions (e.g., user names and types).
list var
List all pre-defined variables including any newly created ones.
Any of these defined variables can be referenced in a string by
placing a “$” before the variable name (e.g., set model m1
trailer $FF ).
Miscellaneous Commands
These commands do not fall under any specific section of the
command shell, but they are used quite frequently.
cancel jobID
Example: cancel d1prn-10
Remove a job from an I/O port queue. Use lpstat to find a
particular job ID first.
chr <string>
Echo <string> or redirect <string> to an I/O port using the
chr <string> ioport .