IBM INFOPRINT 6500 - Manual (Page 192)

Chapter 7 Novell Ethernet Interface Configuration (10/100Base-T)
192
Novell Ethernet Interface Configuration (10/100Base-T)
ADAPTER,
WIRELESS
ADAPTER
There are no mandatory Novell settings needed before the print
server can be detected on the network. However, there can be
some mandatory settings needed before a Novell print queue can
be serviced by the Ethernet Interface. These mandatory settings
are covered separately for Netware 3.
x, 4.x and 5.x under the Host
Configuration heading.
The print server setup in a Novell environment is much simpler than
that required in a TCP/IP one. No addresses, masks, or router
entries are necessary and, in most cases, the Ethernet Interface
can simply be connected to the network, turned on, and then
configured for printing from a Novell station through PCONSOLE or
Netware Administrator.
However, there are some optional parameters you may wish to
change, such as the preferred file server(s), print server password,
polling time, frame type, print server name, NDS context, and NDS
preferred tree. The following sections describe these optional
parameters.
Preferred File Server (NDS and Bindery Setups)
In a bindery setup, the preferred file server specifies the file server
on which the print server object was created. In an NDS setup, it
specifies a file server on which the print server object resides.
Since NDS is distributed, most administrators will not know which
file server(s) the print server object is actually stored on, so in most
NDS environments this option is not used. This feature is useful in a
large Novell network, so that the Ethernet Interface does not ignore
important file servers. If you are setting up the Ethernet Interface to
work with a Bindery file server, it is a good idea to set a preferred
server on the Ethernet Interface.