Intel SGI Altix 450 - Manual (Page 155)

Adding or Replacing PCI/PCI-X Cards
007-4857-002 133
6. To install a half-height PCI card in a carrier, follow these steps:
a. Remove the two screws from the carrier guide bar, as shown in Figure 6-19.
Note: Take care not to lose the threaded inserts in the carrier guide bar.
b. Loosen the third screw of the carrier guide bar.
c. Place the half-height PCI card in the carrier so that the connector edge of the card rests
against the lower guide tab of the carrier (see Figure 6-19).
Figure 6-19 Mounting Half-height PCI Card into Carrier
d. Move the carrier guide bar (adjustment rail) so that it holds the card firmly in place (see
Figure 6-20).
Figure 6-20 Moving Carrier Guide Bar to Secure Half-height PCI Card
Guide tab
Connector edge of PCI card
Remove T8 Torx screws
Loosen T8 Torx screw
Adjustment rail