Intel OPEN (660) 120/140/150 II - Manual (Page 151)

User Manual version 2.1
OPEN (660) 120/140/150
9-141
C: DiskOnChip Installation
The OPEN (660) system is equipped with an internal flash
disk which can emulate a floppy disk drive by adapting
DiskOnChip
 memory chips from 2MB to 144MB capacity,
and the flash disk is fully compatible with floppy disk
format of MS-DOS system. The DOC address setting is
listed below;
DOC address setting
Address
1-2 2-1
DC00 OFF OFF
D800 ON OFF
D400 OFF ON
D000 ON ON
To install a DiskOnChip  memory to the provided socket,
follow the instructions below;
1. Make sure the computer is turned off
2. Insert the DiskOnChip
 memory device into the
onboard socket. Make sure that pin 1 of the
DiskOnChip
 is aligned with the pin 1 of the socket.
3. Power up the computer
4. During the power up, the DiskOnChip
 drivers will be
automatically loaded into the system memory.
5. At this time, the DiskOnChip  can be accessed as
any disk drive.
6. If it is the only disk in the system, it will appear as the
first drive, drive C:.
7. If there are more drives already attached to the
system, then by default, the DiskOnChip  will appear
as the last drive unless specially programmed.
8. If the DiskOnChip  is to be bootable, then follow the
steps below
a.
Use DOS command to copy the operating files
into the DiskOnChip 