Intel OPEN (660) 120/140/150 II - Manual (Page 44)

User Manual version 2.1
OPEN (660) 120/140/150
3-34
System enclosure
Fixture on the
system enclosure
Fixture A
Touchscreen module
3.4.2. Fixing on the System Enclosure’s back panel
1. Cut a window of the same size of
the OPEN system’s panel display
on the system enclosure. The
system enclosure should come
with some brackets. To make the
brackets, please refer to the
diagram of the dimension and
fixing holes of the OPEN system in
Sec. 1.4. Fix the brackets on the 4
sides of the enclosure’s back panel.
The brackets are used to fix the
OPEN system and the system
enclosure together later. The
OPEN system can either be fixed
to brackets of the system
enclosure by screws or by
soldering.
2. Before inserting the OPEN system
into the system enclosure, make sure
all the hardware jumpers and
necessary software are installed.
3. Use metal fixture A to fix the
touchscreen module to the OPEN
system chassis. If no touchscreen is
used, then put a glass or acrylic piece
instead. The touchscreen module
frame is still needed to fix the
transparent piece to the computer.
4. Screw the brackets on the system
enclosure and the metal fixture A on
the OPEN system chassis together with
provided screws.
5. Note: The suggested thickness of the glass or
acrylic used for the transparent piece is between
2mm to 5mm depending on the bronze stick height.
If the system is to be put in public area, it is
suggested to use resilient glass or acrylic to protect
the LCD display.