Intel OPEN (660) 120/140/150 II - Manual (Page 40)

User Manual version 2.1
OPEN (660) 120/140/150
3-30
3.3.2. Front Mounting without Touchscreen Module
If the application does not need the installation of the
touchscreen module, then there are two methods to
mount the OPEN system from the system enclosure’s
front side.
Method 1 with bronze stick
1. Cut a window of the same size of
the OPEN system’s flat panel
display on the system enclosure
and make necessary fixed holes
on it.
2. Before inserting the OPEN system
into the system enclosure, make
sure all the hardware jumpers
and necessary software are
installed.
3. Get a glass or acrylic transparent
piece of the size slighter larger
than the cut window. Glue the
transparent piece to the cut
window verge of the system
enclosure to prevent dust and
water in. It is suggested that the
crevice between the LCD panel
display and transparent piece not
to exceed 1mm.
4. Fix the OPEN system to the
system enclosure with provided
bronze sticks. Be sure to align
the cut window to the OPEN
system's flat panel display.
Note: The suggested thickness of the glass or acrylic
used for the transparent piece is between 2mm
to 5mm depending on the bronze stick height. If
the system is to be put in public area, it is
suggested to use resilient glass or acrylic to
protect the LCD display.
System enclosure
Bronze stick