Intel OPEN (660) 120/140/150 II - Manual (Page 39)

User Manual version 2.1
OPEN (660) 120/140/150
3-29
3.3. Front Mounting
The OPEN system can be mounted to the system
enclosure from the enclosure’s front side. Two conditions
are introduced in this section.
3.3.1. Front Mounting with Touchscreen Module
If the OPEN system comes with
a touchscreen module, to
mount the computer to the
system enclosure from the front
side, follow the steps below;
1. Cut a window of the same size of
the OPEN system’s panel display
on the system enclosure and
make necessary fixed holes on it.
2. Before inserting the OPEN system
into the system enclosure, make
sure all the hardware jumpers
and necessary software are
installed.
3. Glue the cut window verge of
the system enclosure with
close cell tape to prevent
dust and water in.
4. Fix the OPEN system to the
system enclosure with
provided screws. Be sure to
align the cut window to the
OPEN system’s flat panel
display.
Note: The front mounting is the easiest mounting
methods. However, this mounting method will
leave the screws seen on the system enclosure. It
is suggested to use plastic covering or paint to doll
up the system appearance.
Touchscreen
module
Fixture A
System enclosure