Invacare 9000 XT - Manual (Page 24)

9000 Series 24 Part No. 1056953
SECTION 3 FRONT RIGGINGS
FRONT
RIGGINGS
Section 3 - Front Riggings includes the following:
Installing/Removing/Using the Footrest/Legrest
Footrest Height Adjustment
Impact Guards/Calf Strap
Heel Loop Replacement
Raising/Lowering the Elevating Legrest Assembly
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may occur.
INSTALLING/REMOVING/USING THE FOOTREST/LEGREST
(FIGURE 1)
NOTE: This procedure applies to the swingaway
footrest and elevating legrest.
INSTALLING
1. Turn the swingaway footrest assembly
to the side (open footplate is perpen-
dicular to wheelchair).
2. Install the hinge plates on the swing-
away footrest assembly onto the hinge
pins on the wheelchair frame.
3. Push the swingaway footrest assembly towards the inside of the wheelchair until it
locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat this procedure for the other footrest assembly.
REMOVING
1. Push the footrest release lever inward.
2. Rotate swingaway footrest assembly outward.
3. Lift the swingaway footrest assembly off of the hinge pins.
USING
1. To move the footrest out of the way without removing, push the footrest release
lever inward, rotate footrest outward.
2. To lock the footrest, push the swingaway footrest assembly towards the inside of
the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
FIGURE 1 - INSTALLING/REMOVING/
USING THE FOOTREST/LEGREST
Hinge
Pins
Swingaway
Footrest
Assembly
Hinge
Plates
Footrest Release Lever
Footplate