Invacare 9000 XT User Manual

Page 32

Advertising
background image

9000 Series

32

Part No. 1056953

SEAT AND BACK

SECTION 5

REPLACING THE BACK UPHOLSTERY

SCREW ON BACK UPHOLSTERY - 9000 SL (FIGURE 2)

1. Flip swing back arms up and out of the

way. Refer to SWING-BACK ARMS in

SECTION 4 of this manual.

2. Remove the six (6) mounting screws and

washers that secure the EXISTING back

upholstery to the back canes.

3. Cut the tie wraps that secure the EXIST-

ING back upholstery to the wheelchair

frame.

4. Securely tighten the NEW back uphol-

stery to the back canes with the six (6)

mounting screws and washers starting

with the top hole of the back cane.

5. Install two (2) NEW tie wraps through

the bottom holes of the upholstery to

the bottom of the back upholstery to the

back canes.

6. Flip swing-back arms down for use. Refer to SWING-BACK ARMS in SECTION 5 of this

manual.

SLIP ON BACK UPHOLSTERY - 9000 XT/XDT (FIGURE 3)

1. Remove the two (2) mounting screws and

washers that secure the existing back

upholstery to the back canes.

2. Remove the two (2) mounting screws and

locknuts that secure one (1) back cane to

the wheelchair frame.

NOTE: It is necessary to remove only one (1) back

cane to replace the back upholstery.
3. Pull the loose back cane out of the

existing back upholstery.

4. Pull the existing back upholstery up and

over the mounted back cane.

5. Install the NEW back upholstery over the

mounted back cane.

6. Slide the loose back cane through the NEW back upholstery.
7. Secure the back cane to the wheelchair frame with the two (2) allen screws and locknuts.
8. Secure the NEW back upholstery to the back canes with the existing mounting screws and

washers.

FIGURE 2 - REPLACING THE

SCREW ON BACK UPHOLSTERY -

9000 SL

Mounting

Screws

Washers

Washers

Mounting Screws

Back Upholstery

Back

Cane

Tie Wraps

SEAT

AND

BACK

Mounting

Screws

Back Upholstery

Washer

Back Cane

NOTE: The two (2) mounting screws and lock-

nuts that secure the back cane to the wheel-

chair frame are not shown for clarity.

FIGURE 3 - REPLACING THE SLIP

ON BACK UPHOLSTERY -

9000 XT/XDT

Advertising
This manual is related to the following products: