Invacare 9000 XT - Manual (Page 29)

Part No. 1056953 29 9000 Series
NOTE: Armrest release lever MUST be in the
unlocked position when placing armrest into the
arm sockets.
4. Lock the swing-back arms by rotating
the armrest release lever towards the
inside of the wheelchair.
REPLACING DESK/FULL LENGTH ARMREST PAD AND/OR
CLOTHING GUARDS (FIXED HEIGHT ARMS ONLY) (FIGURE 3)
ARMREST PAD
1. Remove the mounting screws that secure
the armrest pad to the armrest assembly.
2. Replace armrest pad and securely tighten
with the existing mounting screws.
CLOTHING GUARD
1. Remove the four (4) mounting screws that
secure the existing clothing guard to the
armrest assembly.
2. Install NEW clothing guard and securely
tighten with the existing mounting screws.
REMOVING OR REPLACING ARMREST (FIGURE 4)
NOTE: This procedure DOES NOT apply to
9000 SL wheelchairs.
WARNING
Make sure the armrest release lever is
in the locked position before using the
wheelchair.
REMOVING ARMRESTS
1. Unlock the armrest by turning the armrest
release levers towards the outside of the
wheelchair.
2. Lift armrest completely out of arm sockets from the wheelchair.
REPLACING ARMRESTS
NOTE: Armrest release levers MUST be in the unlocked position when placing armrests into the arm sockets.
1. Place armrest into arm sockets located on the side of the wheelchair.
2. Lock the armrest by turning the armrest release levers towards the inside of the wheelchair.
FIGURE 3 - REPLACING DESK/
FULL LENGTH ARMREST PAD
AND/OR CLOTHING GUARDS
(FIXED HEIGHT ARMS ONLY)
Clothing
Guard
Armrest
Assembly
Armrest Pad
Mounting Screws
Mounting Screws
Mounting Screws
Armrest
Release
Lever
Arm
Socket
Arm Socket
Armrest
Release
Lever
FIGURE 4 - REMOVING OR
REPLACING ARMREST
Armrest
Swing
Back Arm
Armrest
Release
Lever
Arm Socket
FIGURE 2 - SWING-BACK ARMS -
9000SL, 9000XT, 9000XDT
Front
Rear
SECTION 4 ARMS
ARMS