Invacare 9000 XT - Manual (Page 37)

Part No. 1056953 37 9000 Series
ADJUSTING THE QUICK-RELEASE AXLE (FIGURE 3)
WARNING
NEVER use quick-release axles on the 9000 XT (models with offset axle
option ONLY), 9000XDT or 9000XT RECLINER wheelchairs.
1. Remove rear wheel and quick-release axle from the wheelchair. Refer to REMOV-
ING/INSTALLING THE REAR WHEELS in this section of the manual.
2. Depress detent pin in the quick-release axle and slide axle through the rear wheel hub.
3. Release detent pin ensuring that the locking pins are fully released.
4. Increase or decrease end play by adjusting the locknut on the end of the quick-release
axle.
WARNING
Make sure detent pin and locking pins of the quick-release axles are fully
released BEFORE operating the wheelchair .
Keep locking pins clean.
5. Reinstall rear wheel onto the wheelchair. Refer to REMOVING/INSTALLING THE
REAR WHEELS in this section of the manual.
Detent Pin
Locknut
Locking Pins
Rear
Wheel
Hub
Quick- Release Axle
Axle Spacer
(Conventional
Arms Only)
Axle Bushing
FIGURE 3 - ADJUSTING THE QUICK-RELEASE AXLE
SECTION 6 REAR WHEELS
REAR WHEELS