Invacare 9000 XT - Manual (Page 46)

9000 Series 46 Part No. 1056953
REPLACING THE HEADREST PILLOW (FIGURE 2)
1. Unfasten straps of headrest pillow
from behind headrest upholstery.
2. Secure straps of NEW headrest pillow
onto fastening strips located on back of
headrest upholstery.
REPLACING THE HEADREST/BACK UPHOLSTERY
(FIGURE 3)
HEADREST UPHOLSTERY
1. Remove the headrest pillow. Refer to
REPLACING THE HEADREST PIL-
LOW in this section of the manual.
2. Remove the six (6) mounting screws
that secure the headrest upholstery to
the headrest extension tubes.
3. Secure NEW headrest upholstery onto
headrest extension tubes with the
existing six (6) mounting screws.
4. Install headrest pillow. Refer to RE-
PLACING THE HEADREST PILLOW
in this section of the manual.
BACK UPHOLSTERY
1. Remove one (1) knob on from one (1)
side of the spreader bar.
2. Loosen, but do not remove the re-
maining knob.
NOTE: To remove and install the bottom two
(2) mounting screws of the back upholstery the wheelchair must be partially folded.
3. Remove the twelve (12) mounting screws that secure the back upholstery to the
back canes.
4. Secure NEW back upholstery to back canes with the existing twelve (12) mounting
screws. Securely tighten.
5. Install the knob removed in STEP 1 to secure spreader bar to side frame. Securely
tighten both knobs.
Strap
Fastening
Strips
Headrest Pillow
Strap
Headrest Upholstery
FIGURE 2 - REPLACING THE
HEADREST PILLOW
Headrest
Upholstery
Mounting
Screws
Back
Upholstery
Mounting
Screws
FIGURE 3 - REPLACING THE
HEADREST/BACK UPHOLSTERY
Back
Cane
Headrest
Extension
Tube
Knob
RECLINER SECTION 9
RECLINER