Invacare 9000 XT - Manual (Page 54)

9000 Series 54 Part No. 1056953
OPTIONS SECTION 10
OPTIONS
Section 10 - Options includes the following:
Installing/Cleaning the Telescoping I.V. Rod/O
2
Holders
Installing the Solid Folding Seat
Installing the Crutch and Cane Carrier
Installing the Amputee Bracket - Super Hemi Models Only
Installing the Amputee Bracket - All Models Except Super Hemi
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may occur.
NOTE: The options in this section refer to NON-RECLINER MODELS ONLY, refer to SECTION 9 for
9000XT Recliner options.
INSTALLING/CLEANING
THE TELESCOPING I.V. ROD/
O
2
HOLDERS (FIGURE 1)
INSTALLING
WARNING
The telescoping I.V. rod/O
2
holder
MUST be checked weekly to ensure
it is tightly secured to the wheelchair
frame. If there is any looseness what-
soever, tighten the attachment
hardware securely BEFORE using.
TELESCOPING I.V. ROD HOLDER
ONLY - Make sure the telescoping
I.V. rod is tightly locked BEFORE
placing I.V. medication on the rod.
The telescoping I.V. rod is designed
to support I.V. medication only. DO
NOT use it to support objects other
than I.V. medication.
1. Slide telescoping I.V. rod/O
2
holder over
the step tube of the wheelchair.
NOTE: Mounting bracket of telescoping I.V. rod/
O2 holder should be positioned between the two
(2) axle mounting positions on wheelchair frame.
2. Secure telescoping I.V. rod/O
2
holder to
the wheelchair frame with hex screw,
spacer and locknut.
3. TELESCOPING I.V. ROD HOLDER ONLY - Secure the top of the telescoping I.V. rod
holder to the wheelchair frame with a tie wrap.
FIGURE 1 - INSTALLING THE
TELESCOPING I.V. ROD/O
2
HOLDERS
Telescoping I.V.
Rod Holder
Locknut
Hex Screw
Spacer
Tie Wrap
Mounting
Bracket
Step Tube
Hex
Screw
Spacer
Locknut
Step Tube of Wheelchair
Mounting
Bracket
Axle Mounting Positions