Invacare 9000 XT - Manual (Page 26)

9000 Series 26 Part No. 1056953
SECTION 3 FRONT RIGGINGS
FRONT
RIGGINGS
HEEL LOOP REPLACEMENT (FIGURE 4)
1. Pull the cam lock lever UP to the
UNLOCKED position.
2. Push IN the release buttons and re-
move the lower footrest assembly.
3. Remove the mounting screw, spacer
and locknut that secure the heel loop
to the footrest.
4. Remove EXISTING heel loop from
slide tube.
5. Install NEW heel loop onto slide tube.
6. Install the mounting screw, spacer and
locknut to secure the heel loop to the
footrest. Tighten until the spacer is secure.
7. Insert the lower footrest assembly into the upper footrest assembly to desired
height.
8. Ensure that the release buttons fully protrude from holes on both sides of the upper
footrest support.
9. Rotate cam lock lever DOWN to LOCKED position.
FIGURE 4 - HEEL LOOP
REPLACEMENT
Spacer
Locknut
Cam Lock Lever
Heel Loop
Slide Tube
Mounting Screw
Lower
Footrest
Assembly
Footrest