Invacare 9000 XT - Manual (Page 34)

9000 Series 34 Part No. 1056953
Section 6 - Rear Wheels includes the following:
Removing/Installing the Rear Wheels
Replacing Rear Wheel Handrim
Replacing/Repairing Rear Wheel Tire/Tube
Adjusting the Quick-Release Axle
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage may
occur.
NOTE: The procedures in this section apply to NON-RECLINER models only EXCEPT where
noted. For RECLINER models, refer to SECTION 9 of this manual.
REMOVING/INSTALLING THE REAR WHEELS
WARNING
If changing the size of the rear wheel or a change in the SEAT-TO-
FLOOR HEIGHT is desired, this procedure MUST be performed by a
qualified technician.
PERMANENT AXLES
WARNING
If the wheelchair is equipped with permanent axles, removal/installation
of the rear wheels must be performed by a qualified technician.
QUICK-RELEASE AXLES (FIGURE 1)
WARNING
NEVER use quick-release axles on the 9000 XT (models with offset axle
option ONLY), 9000XDT or 9000XT RECLINER wheelchairs.
NOTE: If replacing the same size rear wheel, note the mounting position on the wheelchair frame
for proper reinstallation of the NEW rear wheel.
1. Push in the detent pin of the quick-release axle (with wheel) and pull the axle out
through the opening in the center of the rear wheel and axle spacer.
NOTE: Axle spacer is used only if wheelchair is equipped with conventional arms.
2. Push in the detent pin of the quick-release axle again and pull the axle out of the
rear wheel.
3. Repeat STEPS 1-2 for the opposite rear wheel.
R
E
A
R
W
H
E
E
L
S
REAR WHEELS SECTION 6
REAR WHEELS