Invacare 9000 XT - Manual (Page 49)

Part No. 1056953 49 9000 Series
SECTION 9 RECLINER
RECLINER
INSTALLING THE ANTI-TIPPERS (FIGURE 15)
1. Install the anti-rattles onto the rear
frame tubes if not already in place.
2. Position the anti-tippers with the anti-
tipper wheels pointing toward the
ground/floor
3. Press the release buttons IN.
4. Insert the anti-tippers into the rear
frame tubing until the bottom release
button locks in place.
NOTE: Refer to the following charts to ensure the correct anti-tipper is installed in the wheelchair.
Seat-to-Floor heights are approximate depending on front caster type.The anti-tipper height mea-
surement MUST be taken with the anti-tipper on a flat surface.
9000 XT RECLINER
WHEEL SIZE SEAT-TO-FLOOR ANTI-TIPPER ON CHAIR OFF CHAIR
REAR/CASTER HEIGHT LENGTH, HEIGHT KIT NUMBER
24/8-inch 19-1/2-inches 11-1/2, 2-1/2-inches 1021767 1021767
22/8-inch 18-1/2-inches 10-1/4, 1-7/8-inches 1061110 1061110
20/8-inch 17-1/2-inches 10, 1-1/2-inches 1061109 1061109
Anti-Tipper Length
Flat Surface Anti-Tipper
Height
Rear
Frame
Tubing
Release Buttons
FIGURE 15 - INSTALLING THE
ANTI-TIPPERS
Anti-tipper
Wheels
Anti-tipper
Anti-Rattle