Juniper Networks M5 - Manual (Page 188)

Pack the Router for Shipment
Figure 54: Routing Engine 600 Serial Number ID Label
1576
Serial number ID label
*1 2 3 4 5 6 7 8 9 1 0 1 2 *
Pack the Router for Shipment
To pack the router for shipment, follow this procedure:
1. Retrieve the shipping box and packing materials in which the router was originally
shipped.
2. On the console or other management device connected to the Routing Engine, enter CLI
operational mode and issue the following command to shut down the router software
cleanly and preserve Routing Engine state information.
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
For more information about the command, see the JUNOS Internet Software Operational
Mode Command Reference: Protocols, Class of Service, Chassis, and Management.
3. Shut down power to the router by pressing the power switch for both power supplies
to the OFF (O) position. On both AC and DC power supplies, the switch is located on
the power supply faceplate.
4. Disconnect power from the router. For instructions, see “Disconnect AC Power from the
Router” on page 102 or “Disconnect DC Power from the Router” on page 109.
5. Remove the cables that connect to all PICs and external devices. For instructions, see
“Replace Connectors to Routing Engine Interface Ports” on page 118 and “Remove a
PIC” on page 87.
168 M5 and M10 Internet Routers Hardware Guide