Juniper Networks M5 - Manual (Page 34)

Craft Interface
For specific information about Routing Engine components (for example, the
capacity of the hard drive), issue the show chassis routing-engine command.
Figure 6: Routing Engine
JUNIPER NETW
ORKS LABEL
THIS SIDE
1596 Extractor clip
PC card slot
RESET
HD
P C C A R D
Extractor clip
PC card slot
LED
Extractor clip Extractor clip
LED
Routing Engine 333 Routing Engine 600
Craft Interface
The craft interface provides status and troubleshooting information at a glance and has
buttons for deactivating alarms and preparing FPCs for removal. The L-shaped craft interface
is located along the left and bottom edges of the front of the chassis, as shown in Figure 1
and Figure 2. It includes the elements shown in Figure 7. (The LEDs for the power supplies
are located on the power supply faceplate, rather than on the craft interface. For more
information, see “Power Supply LEDs and Self-test Button” on page 19.)
Figure 7: Craft Interface
R
1336
Red alarm LED
Lamp test button
Routing Engine
ports
PIC online/offline buttons
Yellow alarm LED
Link status LED
Activity status LED
PIC0/3
PIC1/3
PIC0/2
PIC1/2
PIC0/1
PIC1/1
PIC0/0
PIC1/0
14 M5 and M10 Internet Routers Hardware Guide