JVC VR-509E - Manual (Page 13)

13
Getting Started
[ALARM IN 1 to 9] Terminals
ALARM REC is activated when signals are input to these
terminals. (Page 33)
[EMERGENCY] Terminal
EMERGENCY REC is activated when signals are input to
this terminal. (Page 33)
[CLOCK RST IN] Terminal
The terminal for adjusting the time. The VR-509 clock
(seconds digit) is reset when signals are input. (Page 19)
[CLOCK RST OUT] Terminal
The clock reset signal is output in accordance with the
following timing:
• When the VR-509 internal clock is 00:00 and 12:00.
[ALARM RESET] Terminal
Alarm recording is stopped when this signal is input.
The alarm indicator will be extinguished if a signal is input
with alarm recording stopped.
[REC OUT] Terminal
Outputs the recording status of the VR-509. (Page 29)
[WARNING OUT] Terminal
Outputs a signal when an operation abnormality or error
occurs on the hard disk or other. (Page 96)
[EXT REC IN] Terminal
Activates recording with an external signal. (Page 29)
[OPE ON/OFF] Terminal
Switches between OPERATE ON or OFF when the signal
is input. (Page 16)
[SPOT 1· 2] Terminal
The input signal selects the image to be output with SPOT
OUTPUT. (Page 26)
[COMMON] Terminal
The common grounding terminal. Connected to the signal
grounding terminal on the device connected.
[SIGNAL GND] Terminal
The common grounding terminal. Connected to the signal
grounding terminal on the device connected.
(This can be used when there are insufficient COMMON
grounding terminals.)
* Do not use this terminal for protective earthing.
Part Names and Functions (Signal I/O Terminals)
AC IN 220V - 240V
50Hz/60Hz
WARNING: SHOCK HAZARD
-DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE
PAS OUVRIR
11
12
10
9
8
7
6
5
4
3 2 1
1
2
3
4
5
6
7
8
9
10
11
12