JVC VR-509E - Manual (Page 40)

Playing Back Recorded Images
40
Plays back recorded images. This is activated by running a
search according to the date of the image to be played back
using [SEARCH DATE] (See page 43) or in accordance with
the time when alarm signals are received using the [ALARM
LIST SEARCH] feature. (See page 42)
1. Press the [PLAY/PAUSE] button.
• The [EVENT SEARCH] screen will be displayed.
2. Select [CONTINUOUS PLAYBACK] with [ S/T], and
then press the [SET] button.
• Playback will be started.
„ The OLDEST EVENT/LATEST EVENT will be displayed
when the [SKIP] button is pressed while the [EVENT
SEARCH] screen is being displayed.
3. Press the [PLAY/PAUSE] button.
• Playback will be paused.
• Press the [PLAY/PAUSE] button again to resume
playback.
4. Press the [PLAY STOP] button.
• The screen will return to the [EVENT SEARCH] screen.
5. Press the [PLAY STOP] button once again.
• The [EVENT SEARCH] screen will close.
It is possible to view recorded images when in the Recording
mode.
This will not affect the images being recorded.
1. Press the [PLAY/PAUSE] button during recording.
• Images can be played back with the normal operations
even when recording is in progress.
„ The following modes of playback are possible when in the
Simultaneous Playback mode:
• Normal playback
• Search Alarm (Page 42 “Searching with the Alarm List”)
• Search Date (Page 43 “Searching for Images According
to Date/Time”)
• Jog/Shuttle Playback (Page 43 “Adjusting Playback
Speed”)
• Skip Playback (Page 44 “Skipping Recorded Images”)
Playing Back Images
Pausing during Playback
Ending Playback
EVENT SEARCH
CONTINUOUS PLAYBACK
ALARM LIST SEARCH ..
SEARCH DATE
* * / * * / 2 0 * * * * : * *
SKIP SET ..
Play with PLAY / PAUSE button.
SKIP
OLDEST EVENT
2.
LATEST EVENT
Playing Back during Recording
(Simultaneous Playback Mode)
• There are cases where playback images are displayed
after a delay when playback is activated at the same
time as recording, but this has no adverse effects on
the recording.
• In order to ensure that the hard disk is kept in its
optimal status, the VR-509 will periodically enter the
maintenance mode automatically. When maintenance
is in progress there are cases where the audio sound
may break up or the images be displayed after a delay
during playback. In this case, wait until the mode
display (“DB/”) has disappeared before restarting
playback. (Page 25)
• There are cases where images that have been
recorded close to the most recent recording time
cannot be played back normally if recorded images are
viewed during recording. In this case, stop the
playback for a few moments, and then start it again.
• There are cases where images recorded close to the
times of power failures will not playback normally.
• The VR-509 uses a special recording method that may
result in a loss of synchronization between the images
and the audio sound, depending on the setup
conditions.
CAUTION
Playing Back Recorded Images