Juniper Networks E-Series - Manual (Page 113)

Upgrading Memory on SRP Modules
E-Series Routers
9-7
a cream ceramic connector at one edge. Some or all of the sockets may
already contain SODIMMs.
1 Push down on the back edge of a SODIMM to release it from the
socket (see
Figure 9-2 ).
2
Gently pull up and out to disconnect the SODIMM from the
connectors and remove it from the socket.
Adding New SODIMMs
1
Locate the four SODIMM sockets on the SRP module (see
Figure 9-2 and Figure 9-3 ). See the previous section to learn how to
remove SODIMMs.
Figure 9-2 SODIMM sockets on the SRP-5 and SRP-10 module
SODIMM
Cream ceramic connector
Empty SODIMM socket
NVS card
3. Push down on back edge
of SODIMM until it snaps
into socket.
2. Push SODIMM into
connector at an angle of
approximately 45 degrees.
1. Align notches in
SODIMM and connector.
g013451